View source for Pioneer DJM-800

{{Sound Desk Infobox
|type     = Small Format Digital
|channels = 2 (Mic Inputs)
|stereo   = 4
|eq       = 3 Band
|groups   = 2 (A-B)
|mainout  = 
|auxout   = L & R "Booth"
}}
The '''Pioneer DJM-800''' is a small format, digital mixing console, designed to be used by DJs. It can typically be found at the [[Bop]], connected to two [[Pioneer CDJ1000|CDJ1000s]].

It features 4 stereo/digital input channels with 3-band EQ, two mono input (microphone) channels with 2-band EQ and auto-ducking, an A-B crossfader and a range of sound colour effects and beat effects.

{{clear}}

==Inputs & Outputs==
[[File:DJM-800 IO.png|500px|thumb|right|Click to enlarge]]
===Inputs===
The DJM has 4 digital inputs, which we don't use, so the four Digital input select switches should be set to ''CD'' or ''Line''.

Each channel has two sets of inputs for [[Cables & Connectors/Phono|phono cables]], labelled either ''CD'' and ''Line'' or ''Line'' and ''Phono''.

When a line level signal, such as from a CD player or computer, is being used, the source should be connected to the ''CD'' (or ''Line'' on channels 3/4) inputs in the latter. If the input is from [[Pioneer CDJ1000|CDJs]], [[Cables & Connectors/Jack#Minijack|minijack]] cables should be used to link the ''Control'' input/outputs for the corresponding channels.

Turntables should be connected to the ''Phono'' inputs, and their grounding wires attached to the grounding terminals.

Each channel also has an input select switch at the top of the channel strip; ensure this is set to the correct input when setting up.


The desk also has one combined [[Cables & Connectors/Jack|Jack]]/[[Cables & Connectors/XLR|XLR]] microphone input, and one Jack-only input for microphones. These can be found on the top, in the upper left hand corner.

===Outputs===
The desk has two [[Cables & Connectors/XLR|XLR]] outputs for the main amp stack, labelled as ''Master''.

There is a pair of [[Cables & Connectors/Jack|Jack]] outputs for stereo monitoring, labelled ''Booth''. These should be linked to the monitor amps - though may need a Jack-XLR adapter.

Finally, on the top of the mixer there is a 1/4" jack output for the DJ's headphones. If the DJ brings headphones with a [[Cables & Connectors/Jack#Minijack|minjack]], there are adapters in the Ents Cupboard.

==Tips & Tricks==
* Make sure the DJ stays off the "redline" - the point where the signal meter is in the red "OVER" section. If necessary, lower the trim on each channel strip. ''(The DJM has a master attenuator on the rear which lowers the overall output to a more sensible level - but at or above the redline, the sound can clip or trigger the volume limiter.)''
* When linked with the control cables, the DJM can cause CDJs to start and stop as the channel fader and cross fader reach their upper and lower levels. This may be requested by some DJs, and can confuse others. It is enabled/disabled by depressing the numbered ''Fader Start'' buttons.