View source for StAge

__TOC__
==Location==
The venue was on the ground floor of the union.

It is connected to the [[Club 601]] with a sliding wall and a wall with  projection screens above them. 

At the back of the space, on the second floor, there exists a tech box. 
The seating block is motorised holding 101? people.

==Lighting==
StAge has three main rigging areas: the [[FOHRig#FOH Rig]], the [[Stage#Stage Rig|Stage Rig]] and the {{abbr|LX|Lighting}} Bars, numbered LX1 (nearest the stage), LX2 and LX3 (farthest from stage). At times, the [[space frame]] above the rig are used for rigging lights. In addition, on top of the west wall cabinets, some lights can be positioned to give some attentions to the DJs in some full-venue club night occasions.

There were also 8 side projectors mounted on the ceiling, pointing at retractable screens above the wall on either side of the venue, and a Panasonic projector (≈7k Lumens) pointing at a retractable screen at the back of the stage. These were all linked to HDMI distribution system controlled in the tech box.

Equipment-wise, the venue has
* [[Dimmers/Jands Rack|Jands]] [[Dimmers]]
* [[Clay Paky Alpha Spot HPE 300]]s, [[Clay Paky Alpha Spot 300]]s and [[Clay Paky Alpha Wash 300]]s
* [[Coemar ProSpot 250 LX]]s and [[Coemar ProWash 250 LX]]s Serviced in 2017.
* ChromaQ [[Scrollers]]
* [[Parcan]]s, [[Fresnel]]s, [[Shoebox]]es and [[:Category:Fixtures/Generic/Profile|Profile]]s
* [[ETC ION]] Lighting Desk

==Sound==
The {{abbr|FOH|Front of House}} sound system in the venue was a Martin Audio Wavefront series system. The two stacks of speakers, one on either side of the stage, each comprised:

* 2x [[Martin Audio W8C]] three-way horn-loaded mid-high cabinets
* 3x [[Martin Audio WSX]] front loaded folded horn subwoofer cabinets

Total power handling of the speakers was ~5.6kW AES, ~22.5kW peak.

Notes;
* The subs were the original WSX model with the original RCF L18P300 drivers rated (by Martin) at 600W AES/2.4kW peak. They were NOT the current WSX'''a''' model offered by Martin, which have newer drivers rated at 1kW AES.
* Front-loaded horn subwoofers were a poor choice for indoor use, for use in stacks of less than 4x & for use with an audience closer than 12 feet. Thus sub coverage in the venue was poor, whilst sound pollution outside the venue was high.
* In order to properly cover the width of the venue with mid-high, especially for audience members close to the stage, the W8C cabinets needed to be positioned & splayed correctly. Each W8C cabinet had a 55° horizontal coverage. A 40° splay between 2x W8C cabinets (26cm/10" between cabinet front covers) provided a flat 95° horizontal coverage, which was sufficient to cover the width of the venue when the cabinets were positioned correctly. A smaller splay would not only reduce the horizontal coverage, but also boost the forward output levels - the result being that the centre of the venue was too quiet whilst the areas in front of the speakers was too loud. Essentially, the inner W8C on top of each stack of subs should have been rotated 62.5° inwards (from the perpendicular pointing straight out of the subs toward the rear wall of the venue), whilst the outer W8C on top of each stack should have been rotated 12.5° outwards. However in reality the surface area of the top of the subs wasn't enough to actually rotate the W8C that much without them toppling off...

The venue amp rack contained:
* 2x [[Martin MX5]] [[System Controller]]s
* 1x [[Crest Audio VS1500]] (W8C compression drivers)
* 1x [[C-Audio RA4001]] (W8C 6.5" mid drivers)
* 1x [[Crown XTi 4002]] (W8C 12" low drivers)
* 2x [[JBL MPX1200]] (WSX)

The MX5 units were responsible for taking a full range line-level signal (such as that from a DJ mixer or sound desk) & splitting it into 4x frequency bands (sub, low, mid, high) each of which was output to the respective amp. The MX5's also apply the necessary delays (due to different horn lengths of the different drivers) & had (internally set) limiters to ensure that (even when the AVC2 was bypassed) the speakers could not be damaged by excessive power. The MX5's were mono units, hence why there are 2x of them - one handled the left channel, the other handled the right channel.

The Crest, C-Audio & Crown amps all ran in a stero configuration (eg the Crest powered the left stack's W8C compression drivers from one of its channels & the right stack's W8C compression drivers from its other channel). However the JBL amps each powered one stack's WSX subwoofers - the top unit powered the left stack's subs whilst the bottom unit powered the right stack's subs. On both units channel 1 powered the top sub in its respective stack, whilst channel 2 powered the bottom 2 subs in its respective stack.

Currently [[Behringer X32]] is used as a main console with [[Behringer S16]] Digital Snake.

[[Category:Places]]